Tutorial:  How To Make An IR Mini Emitter

Step 2

	Using a small, sharp drill bit (I used 3mm as this matched the diameter of the cable I was using), make a hole in the side of the base.  As the plastic is quite soft, it is advisable to twist the drill bit by hand between forefinger and thumb. Remove any stray pieces of plastic with a sharp knife if necessary.
	The base should now look similar to this.

<Previous Step     Next Step>

This tutorial created by James Hoye based on a design and working example by Keith Doxey
Copyright © 2001 James Hoye and Keith Doxey